Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
UMCS(4)			 BSD Kernel Interfaces Manual		       UMCS(4)

NAME
     umcs -- USB support for serial adapters based on the MCS7820 and MCS7840
     chips

SYNOPSIS
     To	compile	this driver into the kernel, place the following lines in your
     kernel configuration file:

	   device usb
	   device ucom
	   device umcs

     Alternatively, to load the	driver as a module at boot time, place the
     following line in loader.conf(5):

	   umcs_load="YES"

DESCRIPTION
     The umcs driver provides support for various multiport serial adapters
     based on the MosCom MCS7820 and MCS7840 chips.  They are 2- or 4-port
     adapters with full-featured 16550-compatible UARTs	and very flexible baud
     generators.  Also,	these chips support RS422/RS485	and IrDA operations.

     The device	is accessed through the	ucom(4)	driver which makes it behave
     like a tty(4).

     Different ports on	device are presented as	sub-units, like	/dev/ttyU0.1
     and /dev/ttyU0.2.

HARDWARE
     The umcs driver was tested	on the following adapters:

     +o	 ST Lab	U-360 two-port serial USB adapter
     +o	 ST Lab	U-400 four-port	serial USB adapter

FILES
     /dev/ttyU*.*	for callin ports
     /dev/ttyU*.*.init
     /dev/ttyU*.*.lock	corresponding callin initial-state and lock-state de-
			vices

     /dev/cuaU*.*	for callout ports
     /dev/cuaU*.*.init
     /dev/cuaU*.*.lock	corresponding callout initial-state and	lock-state de-
			vices

SEE ALSO
     tty(4), ucom(4), usb(4)

HISTORY
     The umcs driver appeared in ports since December of 2010.

AUTHORS
     The umcs driver was written by Lev	Serebryakov <lev@FreeBSD.org>.

BUGS
     This driver doesn't support access	to any fine tunes of chip, like
     RS522/RS485 mode, non-standard baudrates, etc.

BSD				April 26, 2017				   BSD

NAME | SYNOPSIS | DESCRIPTION | HARDWARE | FILES | SEE ALSO | HISTORY | AUTHORS | BUGS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=umcs&sektion=4&manpath=FreeBSD+12.0-RELEASE+and+Ports>

home | help