Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
TXP(4)                 FreeBSD Kernel Interfaces Manual                 TXP(4)

     txp -- 3Com 3XP Typhoon/Sidewinder (3CR990) Ethernet interface

     device txp

     The txp interface provides access to the 10Mb/s and 100Mb/s Ethernet net-
     works via the 3Com Typhoon/Sidewinder chipset.  This driver supports the
     following cards:

           +o   3Com 3CR990-TX-95
           +o   3Com 3CR990-TX-97
           +o   3Com 3cR990B-TXM
           +o   3Com 3CR990SVR95
           +o   3Com 3CR990SVR97
           +o   3Com 3cR990B-SRV

     Basic Ethernet functions are provided as well as support for vlan(4) tag
     removal and insertion assistance, receive ip(4), tcp(4), and udp(4)
     checksum offloading, and transmit ip(4) checksum offloading.  There is
     currently no support for transmit tcp(4) or udp(4) checksum offloading,
     tcp(4) segmentation, nor ipsec(4) acceleration.  Note that hardware
     checksumming is only used when the interface is not in bridge(4) mode.

     Each of the host's network addresses is specified at boot time with an
     SIOCSIFADDR ioctl(2).  The txp interface employs the address resolution
     protocol described in arp(4) to dynamically map between Internet and Eth-
     ernet addresses on the local network.

     When a txp interface is brought up, by default, it will attempt to auto-
     negotiate the link speed and duplex mode.  The speeds, in order of
     attempt, are: 100Mb/s Full Duplex, 100Mb/s Half Duplex, 10 Mb/s Full
     Duplex, and 10 Mb/s Half Duplex.

     The txp supports several media types, which are selected via the
     ifconfig(8) command.  The supported media types are:

     media autoselect
             Attempt to autoselect the media type (default)

     media 100baseTX mediaopt full-duplex
             Use 100baseTX, full duplex

     media 100baseTX [mediaopt half-duplex]
             Use 100baseTX, half duplex

     media 10baseT mediaopt full-duplex
             Use 10baseT, full duplex

     media 10baseT [mediaopt half-duplex]
             Use 10baseT, half duplex

     arp(4), ifmedia(4), inet(4), intro(4), ip(4), tcp(4), udp(4), vlan(4),

     The txp driver first appeared in OpenBSD 2.9.

FreeBSD 4.10                    April 15, 2001                    FreeBSD 4.10


Want to link to this manual page? Use this URL:

home | help