Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
QLXGBE(4)		 BSD Kernel Interfaces Manual		     QLXGBE(4)

NAME
     qlxgbe -- QLogic 10 Gigabit Ethernet & CNA	Adapter	Driver

SYNOPSIS
     To	compile	this driver into the kernel, place the following lines in your
     kernel configuration file:

	   device qlxgbe

     To	load the driver	as a module at boot time, place	the following line in
     loader.conf(5):

	   if_qlxgbe_load="YES"

DESCRIPTION
     The qlxgbe	driver supports	IPv4 checksum offload, TCP and UDP checksum
     offload for both IPv4 and IPv6, Large Segment Offload for both IPv4 and
     IPv6, Jumbo frames, VLAN Tag, and Receive Side scaling, ability to	select
     either HW or Software LRO,	when LRO is enabled (default HW	LRO).  For
     further hardware information, see http://www.qlogic.com/.

HARDWARE
     The qlxgbe	driver supports	10 Gigabit Ethernet & CNA Adapter based	on the
     following chipsets:

     +o	 QLogic	8300 series

SUPPORT
     For support questions please contact your QLogic approved reseller	or
     QLogic Technical Support at http://support.qlogic.com, or by E-mail at
     <support@qlogic.com>.

SEE ALSO
     altq(4), arp(4), netintro(4), ng_ether(4),	ifconfig(8)

HISTORY
     The qlxgbe	device driver first appeared in	FreeBSD	10.0.

AUTHORS
     The qlxgbe	driver was written by David C Somayajulu at QLogic Corpora-
     tion.

BSD				 April 1, 2013				   BSD

NAME | SYNOPSIS | DESCRIPTION | HARDWARE | SUPPORT | SEE ALSO | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=qlxgbe&manpath=FreeBSD+12.0-RELEASE+and+Ports>

home | help