Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
vmixctl(7)			  OSS Devices			    vmixctl(7)

NAME
       oss_hdaudio - Intel High	Definition Audio (AZALIA)

DESCRIPTION
       Open  Sound  System  driver  for	 Intels	high definition	audio known as
       "Azalia". This driver supports Intel 915/925 chipsets with the  Realtek
       ALC880 and CMedia 9880 8	channel	codecs.

       The HDA driver supports:

       o  8-96Khz Playback/Recording

       o  8 or 16 or 32	bits

       o  2, 4,	6 or 8 channel audio.

       o  SPDIF	digital	output and Input

       o  AC3 passthrough

   HDAUDIO MIXER
       The Intel HDA mixer is a	new type of mixer that doesn't have the	normal
       volume controls found on	AC97 or	legacy	SB  devices.   The  HDA	 mixer
       presents	a concept of Jacks and you can configure any jack to be	either
       an output or an input jack.

       Some motherboards may not correctly initialize the jacks	 according  to
       their  color  and functionality but in general here's the configuration
       that should generally be	followed:

	      o	Orange = Center/LFE
		     o Blue = Line-in

	      o	Black =	Rear
		     o Green = Front

	      o	Grey = Side
		     o Pink = Mic

       Some Azalia codecs support front	panel connectors and so	if you see fp-
       green  and  fp-pink  connectors,	then these are for front panel speaker
       and mic/line-in Jacks.

	      There is a function selector for most of the analog audio	 jacks
	      (for example connector.pink.mode). This selector is used to con-
	      trol if the jack is used as an input (microphone or line in)  or
	      output (front, rear, side, speaker, etc).

KNOWN PROBLEMS
       In  general Azalia based	systems	(laptops/motherboards) would require a
       custom driver to	work properly. Due to  enormous	 number	 of  different
       systems	it is not possible to develop such custom drivers for all sys-
       tems. A generic driver is used for systems that	don't  have  dedicated
       drivers.

       Unfortunately the mixer and control panel interface (see	ossmix(1)) for
       "generic" systems is very cryptic and difficult to understand. To solve
       problems	 with  volumes	or signal routing you need to start ossxmix(1)
       and change the controls one at time until you get the desired effect.

OPTIONS
       o hdaudio_jacksense
	      enables jack sensing mode	when the hdaudio driver	is loaded.  In
	      this  mode all I/O pin's that are	not in use will	be disabled as
	      well as the mixer	controls that are related with them.  In  this
	      way the mixer/control panel will become more intuitive.  However
	      OSS will need to be restarted with soundoff; soundon every  time
	      new inputs or outputs are	attached to the	audio jacks. Default :
	      0.

	      NOTE! hdaudio_jacksense=1	works only in some systems.  Many lap-
	      tops and motherboards don't support jack sensing.

       o hdaudio_noskip
	      Disable  skipping	 unconnected  jack. All	mixer controls will be
	      shown, even for disabled I/O pins.  Can get values 0-7. 1-7 is a
	      bitmask, where every bit masks a different check.	Bit 3 (= value
	      4) overrides jacksense check  too.   Default:  0	-  unconnected
	      jacks are	skipped.

FILES
       /usr/local/lib/oss/conf/oss_hdaudio.conf	Device configuration file

AUTHOR
       4Front Technologies

			       21 September 2021		    vmixctl(7)

NAME | DESCRIPTION | KNOWN PROBLEMS | OPTIONS | FILES | AUTHOR

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=oss_hdaudio&sektion=7&manpath=FreeBSD+13.0-RELEASE+and+Ports>

home | help