Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
NG_ETF(4)              FreeBSD Kernel Interfaces Manual              NG_ETF(4)

NAME
     ng_etf - Ethertype filtering netgraph node type

SYNOPSIS
     #include <netgraph.h>
     #include <netgraph/ng_etf.h>

DESCRIPTION
     The etf node type multiplexes and filters data between hooks on the basis
     of the ethertype found in an Ethernet header, presumed to be in the first
     14 bytes of the data.  Incoming Ethernet frames are accepted on the
     downstream hook and if the ethertype matches a value which the node has
     been configured to filter, the packet is forwarded out the hook which was
     identified at the time that value was configured.  If it does not match a
     configured value, it is passed to the nomatch hook.  If the nomatch hook
     is not connected, the packet is dropped.

     Packets travelling in the other direction (towards the downstream hook)
     are also examined and filtered.  If a packet has an ethertype that
     matches one of the values configured into the node, it must have arrived
     in on the hook for which that value was configured, otherwise it will be
     discarded.  Ethertypes of values other than those configured by the
     control messages must have arrived via the nomatch hook.

HOOKS
     This node type supports the following hooks:

     downstream             Typically this hook would be connected to a
                            ng_ether(4) node, using the lower hook.

     nomatch                Typically this hook would also be connected to an
                            ng_ether(4) type node using the upper hook.

     <any legal name>       Any other hook name will be accepted and can be
                            used as the match target of an ethertype.
                            Typically this hook would be attached to a
                            protocol handling node that requires and generates
                            packets with a particular set of ethertypes.

CONTROL MESSAGES
     This node type supports the generic control messages, plus the following:

     NGM_ETF_GET_STATUS (getstatus)
           This command returns a struct ng_etfstat containing node statistics
           for packet counts.

     NGM_ETF_SET_FILTER (setfilter)
           Sets the a new ethertype filter into the node and specifies the
           hook to and from which packets of that type should use.  The hook
           and ethertype are specified in a structure of type struct
           ng_etffilter:

               struct ng_etffilter {
                   char        matchhook[NG_HOOKSIZ];  /* hook name */
                   uint16_t    ethertype;              /* this ethertype to this hook */
               };

EXAMPLES
     Using ngctl(8) it is possible to set a filter in place from the command
     line as follows:

         #!/bin/sh
         ETHER_IF=fxp0
         MATCH1=0x834
         MATCH2=0x835
         cat <<DONE >/tmp/xwert
         # Make a new ethertype filter and attach to the Ethernet lower hook.
         # first remove left over bits from last time.
         shutdown ${ETHER_IF}:lower
         mkpeer ${ETHER_IF}: etf lower downstream
         # Give it a name to easily refer to it.
         name ${ETHER_IF}:lower etf
         # Connect the nomatch hook to the upper part of the same interface.
         # All unmatched packets will act as if the filter is not present.
         connect ${ETHER_IF}: etf: upper nomatch
         DONE
         ngctl -f /tmp/xwert

         # something to set a hook to catch packets and show them.
         echo "Unrecognised packets:"
         nghook -a etf: newproto &
         # Filter two random ethertypes to that hook.
         ngctl 'msg etf: setfilter { matchhook="newproto" ethertype=${MATCH1} }
         ngctl 'msg etf: setfilter { matchhook="newproto" ethertype=${MATCH2} }

SHUTDOWN
     This node shuts down upon receipt of a NGM_SHUTDOWN control message, or
     when all hooks have been disconnected.

SEE ALSO
     netgraph(4), ng_ether(4), ngctl(8), nghook(8)

HISTORY
     The ng_etf node type was implemented in FreeBSD 5.0.

AUTHORS
     Julian Elischer <julian@FreeBSD.org>

FreeBSD 11.0-PRERELEASE        November 13, 2012       FreeBSD 11.0-PRERELEASE

NAME | SYNOPSIS | DESCRIPTION | HOOKS | CONTROL MESSAGES | EXAMPLES | SHUTDOWN | SEE ALSO | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=ng_etf&sektion=4&manpath=FreeBSD+10.3-RELEASE+and+Ports>

home | help