Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
LPT(4)                 FreeBSD Kernel Interfaces Manual                 LPT(4)

     lpt -- generic printer device driver

     device ppbus
     device lpt

     device    ppc0 at isa? port IO_LPT1 irq 7
     device    ppc1 at isa? port IO_LPT2 irq 7
     device    ppc2 at isa? port IO_LPT3 irq 7

     For BIOS-probed ports:
     device ppc0 at isa? port? irq 7

     For polled ports:
     device ppc0 at isa? port?
     device ppc1 at isa? port IO_LPT2

     For DMA capable parallel port:
     device ppc0 at isa? port? irq 7 drq 1

     The current lpt driver is the port of the original lpt driver to the
     ppbus(4) system.

     One purpose of this port was to allow parallel port sharing with other
     parallel devices.  Secondly, inb()/outb() calls have been replaced by
     ppbus function calls.  lpt is now arch-independent thanks to the ppbus
     interface.  See ppbus(4) for more info about the ppbus system.

     The parallel port bus is allocated by lpt when the printer device is
     opened and released only when the transfer is completed: either when the
     device is closed or when the entire buffer is sent in interrupt driven

     The driver can be configured to be either interrupt-driven, or to poll
     the printer.  Ports that are configured to be interrupt-driven can be
     switched to polled mode by using the lptcontrol(8) command.

     Depending on your hardware, extended capabilities may be configured with
     the lptcontrol(8) command.  With an ECP/ISA port, you can take advantage
     of FIFO and DMA.

     In order to retrieve printer info from /dev/lpt0, just apply the cat com-
     mand to the device.  If the printer supports IEEE1284 nibble mode and has
     data to send to the host, you'll get it.

     ppbus(4), lptcontrol(8)

     This driver replaces the functionality of the lpa driver, which is now

     /dev/lpt0                         first parallel port driver

     There are lots of them, especially in cheap parallel port implementa-

     It is only possible to open a lpt port when a printer is connected and
     on-line, making it impossible to run lptcontrol(8) when there is no
     printer connected.

     This driver could still stand a rewrite.

FreeBSD 4.10                   February 14, 1999                  FreeBSD 4.10


Want to link to this manual page? Use this URL:

home | help