Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
git-annex-registerurl(1)    General Commands Manual   git-annex-registerurl(1)

NAME
       git-annex-registerurl - registers an url	for a key

SYNOPSIS
       git annex registerurl [key url]

DESCRIPTION
       This  plumbing-level  command  can be used to register urls where a key
       can be downloaded from.

       No verification is performed of the url's contents.

       Normally	the key	is a git-annex formatted key. However, to make it eas-
       ier  to use this	to add urls, if	the key	cannot be parsed as a key, and
       is a valid url, an URL key is constructed from the url.

OPTIONS
       --batch

	      In batch input mode, lines are read from stdin,  and  each  line
	      should contain a key and url, separated by a single space.

	      For  backwards  compatability with old git-annex before this op-
	      tion was added, when no key and url pair are  specified  on  the
	      command  line,  batch  input is used, the	same as	if the --batch
	      option were specified. It	is however recommended to use --batch.

       -z     When in batch mode, the input is delimited by nulls  instead  of
	      the usual	newlines.

	      (Note  that  for	this to	be used, you have to explicitly	enable
	      batch mode with --batch)

       Also the	git-annex-common-options(1) can	be used.

SEE ALSO
       git-annex(1)

       git-annex-addurl(1)

       git-annex-unregisterurl(1)

AUTHOR
       Joey Hess <id@joeyh.name>

						      git-annex-registerurl(1)

NAME | SYNOPSIS | DESCRIPTION | OPTIONS | SEE ALSO | AUTHOR

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=git-annex-registerurl&sektion=1&manpath=FreeBSD+13.0-RELEASE+and+Ports>

home | help