Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
git-annex-registerurl(1)    General Commands Manual   git-annex-registerurl(1)

NAME
       git-annex-registerurl - registers an url	for a key

SYNOPSIS
       git annex registerurl [key url]

DESCRIPTION
       This  plumbing-level  command  can be used to register urls where a key
       can be downloaded from.

       No verification is performed of the url's contents.

       If no key and url pair are specified on the command line,  batch	 input
       is used,	the same as if the --batch option were specified.

       Normally	the key	is a git-annex formatted key. However, to make it eas-
       ier to use this to add urls, if the key cannot be parsed	as a key,  and
       is a valid url, an URL key is constructed from the url.

OPTIONS
       --batch

	      In  batch	 input	mode, lines are	read from stdin, and each line
	      should contain a key and url, separated by a single space.

       -z     When in batch mode, the input is delimited by nulls  instead  of
	      the usual	newlines.

	      (Note  that  for	this to	be used, you have to explicitly	enable
	      batch mode with --batch)

SEE ALSO
       git-annex(1)

       git-annex-addurl(1)

AUTHOR
       Joey Hess <id@joeyh.name>

						      git-annex-registerurl(1)

NAME | SYNOPSIS | DESCRIPTION | OPTIONS | SEE ALSO | AUTHOR

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=git-annex-registerurl&sektion=1&manpath=FreeBSD+12.2-RELEASE+and+Ports>

home | help