Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
git-annex-fromkey(1)	    General Commands Manual	  git-annex-fromkey(1)

NAME
       git-annex-fromkey - adds	a file using a specific	key

SYNOPSIS
       git annex fromkey [key file ...]

DESCRIPTION
       This  plumbing-level  command  can be used to manually set up a file in
       the git repository to link to a specified key.

       Multiple	pairs of file and key can be given in a	single command line.

       If no key and file pair are specified on	the command line, batch	 input
       is used,	the same as if the --batch option were specified.

       Normally	the key	is a git-annex formatted key. However, to make it eas-
       ier to use this to add urls, if the key cannot be parsed	as a key,  and
       is  a valid url,	an URL key is constructed from the url.	Note that this
       does not	register the url as a location of the key; use	git-annex-reg-
       isterurl(1) to do that.

OPTIONS
       --force

	      Allow  making  a	file link to a key whose content is not	in the
	      local repository.	The key	may not	be known to git-annex at all.

       --batch
	      In batch input mode, lines are read from stdin,  and  each  line
	      should contain a key and filename, separated by a	single space.

       -z     When  in	batch mode, the	input is delimited by nulls instead of
	      the usual	newlines.

	      (Note that for this to be	used, you have	to  explicitly	enable
	      batch mode with --batch)

       --json Enable  JSON  output.  This is intended to be parsed by programs
	      that use git-annex. Each line of output is a JSON	object.

SEE ALSO
       git-annex(1)

AUTHOR
       Joey Hess <id@joeyh.name>

							  git-annex-fromkey(1)

NAME | SYNOPSIS | DESCRIPTION | OPTIONS | SEE ALSO | AUTHOR

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=git-annex-fromkey&sektion=1&manpath=FreeBSD+12.2-RELEASE+and+Ports>

home | help