Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help
BLACKLISTCTL(8)		FreeBSD	System Manager's Manual	       BLACKLISTCTL(8)

NAME
     blacklistctl -- display and change	the state of blacklistd

SYNOPSIS
     blacklistctl dump [-abdnrw]

DESCRIPTION
     blacklistctl is a program used to display the state of blacklistd(8)

     The following options are available:

     -a	     Show all database entries,	by default it shows only the embryonic
	     ones.

     -b	     Show only the blocked entries.

     -d	     Increase debugging	level.

     -n	     Don't display a header.

     -r	     Show the remaining	blocked	time instead of	the last activity
	     time.

     -w	     Normally the width	of addresses is	good for IPv4, the -w flag,
	     makes the display wide enough for IPv6 addresses.

SEE ALSO
     blacklistd(8)

NOTES
     Sometimes the reported number of failed attempts can exceed the number of
     attempts that blacklistd(8) is configured to block.  This can happen
     either because the	rule has been removed manually,	or because there were
     more attempts in flight while the rule block was being added.  This con-
     dition is normal; in that case blacklistd(8) will first attempt to	remove
     the existing rule,	and then it will re-add	it to make sure	that there is
     only one rule active.

HISTORY
     blacklistctl first	appeared in NetBSD 7.  FreeBSD support for
     blacklistctl was implemented in FreeBSD 11.

AUTHORS
     Christos Zoulas

FreeBSD	Ports 11.2		 June 7, 2016		    FreeBSD Ports 11.2

NAME | SYNOPSIS | DESCRIPTION | SEE ALSO | NOTES | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=blacklistctl&manpath=FreeBSD+12.0-RELEASE+and+Ports>

home | help