Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
ATAPICAM(4)            FreeBSD Kernel Interfaces Manual            ATAPICAM(4)

NAME
     atapicam - CAM XPT (transport) module for ATAPI devices

SYNOPSIS
     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device scbus
           device ata
           device atapicam

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           atapicam_load="YES"

DESCRIPTION
     The ATAPI/CAM module allows ATAPI devices (CD-ROM, CD-RW, DVD drives,
     floppy drives such as Iomega Zip, tape drives) to be accessed through the
     SCSI subsystem, cam(4).

     ata(4) and scbus(4) must be configured in the kernel as well.  The SCSI
     target drivers (cd(4), da(4), or st(4)) can then be used to access the
     devices.  The generic passthrough device, pass(4), can also be used to
     send SCSI commands directly to the devices through the CAM API.

     A separate CAM bus is created for each ATA bus in the system.  On each of
     these buses, target ID 0 is assigned to the master device, and ID 1 is
     assigned to the slave (provided they are ATAPI devices).

IMPLEMENTATION NOTES
     Some SCSI commands are intercepted by the driver, and undergo special
     processing in order to work around limitations of ATAPI devices.  Such
     limitations can be consequences of the ATAPI specification.  For example,
     ATAPI devices do not implement the 6-byte versions of MODE_SELECT,
     MODE_SENSE, READ, or WRITE.  They can also be common bugs, such as
     hanging when queried for extended INQUIRY information.

EXAMPLES
           device ata
           device atapicam
           device scbus
           device cd
           device pass

     Add the atapicam driver to the kernel.

           camcontrol devlist

     Print the list of all devices available through CAM.

           mount -t cd9660 /dev/cd0 /mnt

     Mount a CD-ROM from an ATAPI CD-ROM drive (the command above assumes that
     the ATAPI drive is the only CD-ROM unit).

SEE ALSO
     ata(4), cam(4), scsi(4), atacontrol(8), camcontrol(8)

HISTORY
     The ATAPI/CAM driver first appeared in FreeBSD 4.8 and FreeBSD 5.0.

AUTHORS
     The ATAPI/CAM driver was written by Thomas Quinot <thomas@FreeBSD.org>.

BUGS
     atapicam and ATAPI-specific target drivers (acd(4), ast(4), and afd(4))
     can be configured in the same kernel.  Simultaneous access to the same
     device through the SCSI generic drivers and the ATAPI-specific drivers
     may cause problems and is strongly discouraged.

FreeBSD 11.0-PRERELEASE        October 22, 2009        FreeBSD 11.0-PRERELEASE

NAME | SYNOPSIS | DESCRIPTION | IMPLEMENTATION NOTES | EXAMPLES | SEE ALSO | HISTORY | AUTHORS | BUGS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=atapicam&sektion=4&manpath=FreeBSD+9.3-RELEASE>

home | help