Skip site navigation (1)Skip section navigation (2)

FreeBSD Manual Pages

  
 
  

home | help 
amttool(1)		    General Commands Manual		    amttool(1)

NAME
       amttool - remotely control Intel	AMT managed machines.

SYNOPSIS
       amttool host [ command ]	[ arg(s) ]

DESCRIPTION
       amttool	is  a  perl  script which speaks SOAP to Intel AMT managed ma-
       chines.	It can query informations about	the machine  in	 question  and
       also send some commands for basic remote	control.

       host  is	 the hostname or IP address of the machine amttool should con-
       trol.  command is an optional command.

       You must	set fill AMT_PASSWORD environment variable with	the AMT	 pass-
       word.

       For more	inforamtions on	Intel AMT check	amt-howto(7).

COMMANDS
       info   gather information (default).

       reset [ special ]
	      reset  machine,  with  optional special command (see section be-
	      low).

       powerup [ special ]
	      turn on machine.

       powerdown
	      turn off machine.

       powercycle [ special ]
	      powercycle machine.

       netinfo
	      print network configuration (requires AMT	2.5+).

       netconf if link [ ip mask gw [ dns1 [ dns2 ]]]
	      configure	network	interface (requires AMT	2.5+).	if is the  in-
	      terface  handle, link the	link policy.  If in doubt just feed in
	      what the netinfo command prints.	ip is the IPv4	address,  mask
	      the  netmask,  gw	the default gateway, dns1 and dns2 are the DNS
	      Servers.	If no IP configuration is specified the	tool tries  to
	      configure	the machine in shared mac address mode with dhcp, oth-
	      erwise in	separate mac address mode with static IP address.  De-
	      fault for	dns1 is	the gateway address, for dns2 it is 0.0.0.0.

SPECIAL	COMMANDS
       Special	commands  can  optionally  be specified	for reset, powerup and
       powercycle.  They change	the default boot behavior of the machine.

       bios   Asks for the BIOS	boot messages being redirected to serial-over-
	      lan.

       pxe    Network boot via PXE.

       hd     Boot from	local disk.

       hdsafe Boot from	local disk (safe mode).

       cd     Boot from	CD/DVD.

       diag   Boot in diagnostics mode.

ENVIRONMENT
       AMT_PASSWORD
	      AMT password.

       AMT_DEBUG
	      Enable debug output.

SEE ALSO
       amtterm(1), gamt(1), amt-howto(7)

AUTHOR
       (c) 2007	Gerd Hoffmann <kraxel@redhat.com>

			   (c) 2007,08 Gerd Hoffmann		    amttool(1)
NAME | SYNOPSIS | DESCRIPTION | COMMANDS | SPECIAL COMMANDS | ENVIRONMENT | SEE ALSO | AUTHOR

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=amttool&sektion=1&manpath=FreeBSD+12.0-RELEASE+and+Ports>

home | help