Chapter 30. Firewalls

Contributed by Joseph J. Barbish.
Converted to SGML and updated by Brad Davis.
Table of Contents
30.1. Synopsis
30.2. Firewall Concepts
30.3. PF
30.4. IPFW
30.5. IPFILTER (IPF)

30.1. Synopsis

Firewalls make it possible to filter the incoming and outgoing traffic that flows through a system. A firewall can use one or more sets of rules to inspect network packets as they come in or go out of network connections and either allows the traffic through or blocks it. The rules of a firewall can inspect one or more characteristics of the packets such as the protocol type, source or destination host address, and source or destination port.

Firewalls can enhance the security of a host or a network. They can be used to do one or more of the following:

  • Protect and insulate the applications, services, and machines of an internal network from unwanted traffic from the public Internet.

  • Limit or disable access from hosts of the internal network to services of the public Internet.

  • Support network address translation (NAT), which allows an internal network to use private IP addresses and share a single connection to the public Internet using either a single IP address or a shared pool of automatically assigned public addresses.

FreeBSD has three firewalls built into the base system: PF, IPFW, and IPFILTER, also known as IPF. FreeBSD also provides two traffic shapers for controlling bandwidth usage: altq(4) and dummynet(4). ALTQ has traditionally been closely tied with PF and dummynet with IPFW. Each firewall uses rules to control the access of packets to and from a FreeBSD system, although they go about it in different ways and each has a different rule syntax.

FreeBSD provides multiple firewalls in order to meet the different requirements and preferences for a wide variety of users. Each user should evaluate which firewall best meets their needs.

After reading this chapter, you will know:

  • How to define packet filtering rules.

  • The differences between the firewalls built into FreeBSD.

  • How to use and configure the PF firewall.

  • How to use and configure the IPFW firewall.

  • How to use and configure the IPFILTER firewall.

Before reading this chapter, you should:

  • Understand basic FreeBSD and Internet concepts.

Note:

Since all firewalls are based on inspecting the values of selected packet control fields, the creator of the firewall ruleset must have an understanding of how TCP/IP works, what the different values in the packet control fields are, and how these values are used in a normal session conversation. For a good introduction, refer to Daryl's TCP/IP Primer.

All FreeBSD documents are available for download at http://ftp.FreeBSD.org/pub/FreeBSD/doc/

Questions that are not answered by the documentation may be sent to <freebsd-questions@FreeBSD.org>.
Send questions about this document to <freebsd-doc@FreeBSD.org>.