Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
RC(4)                  FreeBSD Kernel Interfaces Manual                  RC(4)

NAME
     rc -- RISCom/8 multiport card

SYNOPSIS
     device isa
     device rc

DESCRIPTION
     The RISCom/8 is an eight port ISA RS-232C communications multiplexer with
     a built in RISC processor.  It uses a block of sixteen I/O ports in the
     range 0x200 to 0x3f0 selectable by on-board switches or jumpers.  The
     block must be aligned on a sixteen port boundary.  The jumper-selectable
     hardware interrupt level may be set to be detected during system initial-
     ization using settings found in the /boot/device.hints file.

     This driver is mostly based on the Cirrus Logic CL-CD180 driver.

HARDWARE
     The rc driver provides support for the SDL Communications RISCom/8
     boards.

DIAGNOSTICS
     The following driver specific error messages may be reported:

     rc%d channel%d: interrupt-level buffer overflow  An internal buffer over-
     flow error has occurred on the listed channel.  The rc driver will need
     to be reloaded to correct this.

     rc%d: Bad char chan %d  The channel has obtained a bad set of characters.

     rc%d: Got extra chars chan %d  The rc driver got more characters than
     expected on the channel shown.

     rc%d: data mismatch chan %d ptr %d (%d != %d)  Data sent from channel %d
     to the rx buffer was different then expected.

     rc%d: channel %d command timeout, rc.c line: %d  A command timeout has
     occurred on the channel, the src/sys/dev/rc/rc.c file can be consulted
     for more information.

SEE ALSO
     tty(1), ttyname(3), sio(4), tty(4), device.hints(5), comcontrol(8),
     getty(8), mutex(9), splx(9)

     http://www.sdlcomm.com

HISTORY
     The rc driver first appeared in FreeBSD 2.0.5.  This manual page first
     appeared in FreeBSD 5.3.

AUTHORS
     This manual page was written by Tom Rhodes <trhodes@FreeBSD.org>.

BUGS
     The rc driver code still uses the spl(9) functions.  These should be
     replaced by mutex(9) functions.

     The various ttyld_*() functions should be documented.

FreeBSD 6.2                     March 18, 2005                     FreeBSD 6.2

NAME | SYNOPSIS | DESCRIPTION | HARDWARE | DIAGNOSTICS | SEE ALSO | HISTORY | AUTHORS | BUGS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=rc&sektion=4&manpath=FreeBSD+6.2-RELEASE>

home | help