Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
NG_TTY(4)              FreeBSD Kernel Interfaces Manual              NG_TTY(4)

NAME
     ng_tty -- netgraph node type that is also a line discipline

SYNOPSIS
     #include <sys/types.h>
     #include <sys/ttycom.h>
     #include <netgraph/ng_tty.h>

DESCRIPTION
     The tty node type is both a netgraph node type and a line discipline.  A
     new node is created when the corresponding line discipline, NETGRAPHDISC,
     is registered on a tty device (see tty(4)).

     The node has a single hook called hook.  Incoming bytes received on the
     tty device are sent out on this hook, and frames received on hook are
     transmitted out on the tty device.  No modification to the data is per-
     formed in either direction.  While the line discipline is installed on a
     tty, the normal read and write operations are unavailable, returning EIO.

     The node supports an optional ``hot character''.  If set to non-zero,
     incoming data from the tty device is queued until this character is seen.
     This avoids sending lots of mbufs containing a small number of bytes, but
     introduces potentially infinite latency.  The default hot character is
     0x7e, consistent with hook being connected to a ng_async(4) type node.
     The hot character has no effect on the transmission of data.

     The node will attempt to give itself the same netgraph name as the name
     of the tty device.  In any case, information about the node is available
     via the netgraph ioctl(2) command NGIOCGINFO.  This command returns a
     struct nodeinfo similar to the NGM_NODEINFO netgraph control message.

HOOKS
     This node type supports the following hooks:

     hook    tty(4) serial data contained in mbuf structures, with arbitrary
             inter-frame boundaries.

CONTROL MESSAGES
     This node type supports the generic control messages, plus the following:

     NGM_TTY_SET_HOTCHAR
          This command takes an integer argument and sets the hot character
          from the lower 8 bits.  A hot character of zero disables queueing,
          so that all received data is forwarded immediately.

     NGM_TTY_GET_HOTCHAR
          Returns an integer containing the current hot character in the lower
          eight bits.

SHUTDOWN
     This node shuts down when the corresponding device is closed (or the line
     discipline is uninstalled on the device).  The NGM_SHUTDOWN control mes-
     sage is not valid, and always returns the error EOPNOTSUPP.

SEE ALSO
     ioctl(2), netgraph(4), ng_async(4), tty(4), ngctl(8)

HISTORY
     The ng_tty node type was implemented in FreeBSD 4.0.

AUTHORS
     Archie Cobbs <archie@FreeBSD.org>

BUGS
     The serial driver code also has a notion of a ``hot character''.  Unfor-
     tunately, this value is statically defined in terms of the line disci-
     pline and cannot be changed.  Therefore, if a hot character other than
     0x7e (the default) is set for the ng_tty node, the node has no way to
     convey this information to the serial driver, and sub-optimal performance
     may result.

FreeBSD 6.2                    January 19, 1999                    FreeBSD 6.2

NAME | SYNOPSIS | DESCRIPTION | HOOKS | CONTROL MESSAGES | SHUTDOWN | SEE ALSO | HISTORY | AUTHORS | BUGS

Want to link to this manual page? Use this URL:
<http://www.freebsd.org/cgi/man.cgi?query=ng_tty&sektion=4&manpath=FreeBSD+6.2-RELEASE>

home | help