Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
MALO(4)		       FreeBSD Kernel Interfaces Manual		       MALO(4)

NAME
     malo -- Marvell Libertas IEEE 802.11b/g wireless network driver

SYNOPSIS
     To	compile	this driver into the kernel, place the following lines in your
     kernel configuration file:

	   device malo
	   device pci
	   device wlan
	   device firmware

     Alternatively, to load the	driver as a module at boot time, place the
     following lines in	loader.conf(5):

	   if_malo_load="YES"

DESCRIPTION
     The malo driver provides support for Marvell Libertas 88W8335 based PCI
     and Cardbus network adapters.  malo supports station and monitor mode
     operation.	 Only one virtual interface may	be configured at any time.
     For more information on configuring this device, see ifconfig(8).

     This driver requires the malofw firmware kernel module be installed
     before it will work.  The firmware	files are not publicly available.  A
     port of the firmware can be found at:

	   http://weongyo.org/project/malo/malo-firmware-1.4.tar.gz

     The firmware kernel module	can be installed by extracting the archive and
     running `make install clean' in the malo-firmware-1.4 directory.

HARDWARE
     The following cards are among those supported by the malo driver:

	   Card			  Chip	     Bus	Standard
	   Netgear WG311v3	  88W8335    PCI	b/g
	   Tenda TWL542P	  88W8335    PCI	b/g
	   U-Khan UW-2054i	  88W8335    PCI	b/g

EXAMPLES
     Join an existing BSS network (i.e., connect to an access point):

	   ifconfig wlan create	wlandev	malo0 inet 192.168.0.20	\
	       netmask 0xffffff00

     Join a specific BSS network with network name ``my_net'':

	   ifconfig wlan create	wlandev	malo0 ssid my_net up

     Join a specific BSS network with 64-bit WEP encryption:

	   ifconfig wlan create	wlandev	malo0 ssid my_net \
		   wepmode on wepkey 0x1234567890 weptxkey 1 up

SEE ALSO
     cardbus(4), pci(4), wlan(4), wlan_ccmp(4),	wlan_tkip(4), wlan_wep(4),
     ifconfig(8), wpa_supplicant(8)

HISTORY
     The malo device driver first appeared in FreeBSD 7.1.

FreeBSD	10.1		       October 21, 2009			  FreeBSD 10.1

NAME | SYNOPSIS | DESCRIPTION | HARDWARE | EXAMPLES | SEE ALSO | HISTORY

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=malo&sektion=4&manpath=FreeBSD+8.2-RELEASE>

home | help