Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
IICBUS(4)	       FreeBSD Kernel Interfaces Manual		     IICBUS(4)

NAME
     iicbus -- I2C bus system

SYNOPSIS
     device iicbus
     device iicbb

     device iic
     device ic
     device iicsmb

DESCRIPTION
     The iicbus	system provides	a uniform, modular and architecture-indepen-
     dent system for the implementation	of drivers to control various I2C
     devices and to utilize different I2C controllers.

I2C
     I2C is an acronym for Inter Integrated Circuit bus.  The I2C bus was
     developed in the early 1980's by Philips semiconductors.  It's purpose
     was to provide an easy way	to connect a CPU to peripheral chips in	a TV-
     set.

     The BUS physically	consists of 2 active wires and a ground	connection.
     The active	wires, SDA and SCL, are	both bidirectional.  Where SDA is the
     Serial DAta line and SCL is the Serial CLock line.

     Every component hooked up to the bus has its own unique address whether
     it	is a CPU, LCD driver, memory, or complex function chip.	 Each of these
     chips can act as a	receiver and/or	transmitter depending on its function-
     ality.  Obviously an LCD driver is	only a receiver, while a memory	or I/O
     chip can both be transmitter and receiver.	 Furthermore there may be one
     or	more BUS MASTERs.

     The BUS MASTER is the chip	issuing	the commands on	the BUS.  In the I2C
     protocol specification it is stated that the IC that initiates a data
     transfer on the bus is considered the BUS MASTER.	At that	time all the
     others are	regarded to as the BUS SLAVEs.	As mentioned before, the IC
     bus is a Multi-MASTER BUS.	 This means that more than one IC capable of
     initiating	data transfer can be connected to it.

DEVICES
     Some I2C device drivers are available:

     Devices	       Description
     iic	       general i/o operation
     ic		       network IP interface
     iicsmb	       I2C to SMB software bridge

INTERFACES
     The I2C protocol may be implemented by hardware or	software.  Software
     interfaces	rely on	very simple hardware, usually two lines	twiddled by 2
     registers.	 Hardware interfaces are more intelligent and receive 8-bit
     characters	they write to the bus according	to the I2C protocol.

     I2C interfaces may	act on the bus as slave	devices, allowing spontaneous
     bidirectional communications, thanks to the multi-master capabilities of
     the I2C protocol.

     Some I2C interfaces are available:

     Interface		  Description
     pcf		  Philips PCF8584 master/slave interface
     iicbb		  generic bit-banging master-only driver
     lpbb		  parallel port	specific bit-banging interface
     bktr		  Brooktree848 video chipset, hardware and software
			  master-only interface

SEE ALSO
     iicbb(4), lpbb(4),	pcf(4)

HISTORY
     The iicbus	manual page first appeared in FreeBSD 3.0.

AUTHORS
     This manual page was written by Nicolas Souchu.

FreeBSD	10.1			August 6, 1998			  FreeBSD 10.1

NAME | SYNOPSIS | DESCRIPTION | I2C | DEVICES | INTERFACES | SEE ALSO | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<http://www.freebsd.org/cgi/man.cgi?query=iicbus&sektion=4&manpath=FreeBSD+4.5-RELEASE>

home | help