Skip site navigation (1)Skip section navigation (2)

FreeBSD Man Pages

Man Page or Keyword Search:
Man Architecture
Apropos Keyword Search (all sections) Output format
home | help
AXE(4)		       FreeBSD Kernel Interfaces Manual			AXE(4)

NAME
     axe -- ASIX Electronics AX88172 USB Ethernet driver

SYNOPSIS
     device ehci
     device uhci
     device ohci
     device usb
     device miibus
     device axe

DESCRIPTION
     The axe driver provides support for USB ethernet adapters based on	the
     ASIX Electronics AX88172 USB 2.0 chipset, including the following:

     +o	 D-Link	DUBE100
     +o	 LinkSys USB200M
     +o	 Netgear FA120

     The AX88172 is a USB 2.0 device which contains a 10/100 ethernet MAC with
     MII interface and is designed to work with	both ethernet and HomePNA
     transceivers.  The	AX88172	will operate with both USB 1.x and USB 2.0
     controllers, however performace with 1.x contollers will be limited since
     the USB 1.x standard specifies a maximum transfer speed of	12Mbps.	 Users
     with USB 1.x controllers should therefore not expect to actually achieve
     100Mbps speeds with these devices.

     The AX88172 supports a 64-bit multicast hash table, single	perfect	filter
     entry for the station address, all-multicast mode and promiscuous mode.
     Packets are received and transmitted over separate	USB bulk transfer end-
     points.

     The axe driver supports the following media types:

     autoselect	  Enable autoselection of the media type and options.  The
		  user can manually override the autoselected mode by adding
		  media	options	to the /etc/rc.conf file.

     10baseT/UTP  Set 10Mbps operation.	 The mediaopt option can also be used
		  to enable full-duplex	operation.  Not	specifying full-duplex
		  implies half-duplex mode.

     100baseTX	  Set 100Mbps (fast ethernet) operation.  The mediaopt option
		  can also be used to enable full-duplex operation.  Not spec-
		  ifying full-duplex implies half-duplex mode.

     The axe driver supports the following media options:

     full-duplex  Force	full duplex operation.	The interface will operate in
		  half duplex mode if this media option	is not specified.

     For more information on configuring this device, see ifconfig(8).

DIAGNOSTICS
     axe%d: watchdog timeout  A	packet was queued for transmission and a
     transmit command was issued, however the device failed to acknowledge the
     transmission before a timeout expired.

     axe%d: no memory for rx list  The driver failed to	allocate an mbuf for
     the receiver ring.

SEE ALSO
     arp(4), miibus(4),	netintro(4), ng_ether(4), ifconfig(8)

     ASIX AX88172 data sheet, http://www.asix.com.tw.

HISTORY
     The axe device driver first appeared in FreeBSD 5.0.

AUTHORS
     The axe driver was	written	by Bill	Paul <wpaul@windriver.com>.

FreeBSD	10.1			April 20, 2003			  FreeBSD 10.1

NAME | SYNOPSIS | DESCRIPTION | DIAGNOSTICS | SEE ALSO | HISTORY | AUTHORS

Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=axe&sektion=4&manpath=FreeBSD+5.2.1-RELEASE>

home | help